Use Original Texas Instruments USA LM2596 Max 3.0 Ampere
High-power LED Adjustable CONSTANT CURRENT driver
Solar Panels and Wind turbines
For LED constant current driver usage:
Make sure operating current and Max operating Voltage of the LED you need to drive.
Adjust the constant voltage potentiometer to make sure the out put Voltage is up to LED Max operating Voltage.
Join LED,test.
(1,2,3,4 steps to connect the power module input and output load does not take LED.)
Features:
Non-isolated step-down constant voltage module (CV) plus constant current (CC)
Input voltage: 7-35V
Output voltage: continuously adjustable (1.25-30V)
Minimum Voltage difference: 2V
Output current: rated 2A, (more than 15W, please install the heat sink)
Size: ultra-small size 49 (L) * 23.4 (W) * 14 (H) mm
Output power: natural cooling 15W, 25W with heatsink
Conversion efficiency: up to 92% (output voltage higher, higher the efficiency)
Output ripple: 20M bandwidth (for reference only)
Input 12V Output 5V 2A 60mV (MAX)
Operating temperature: Industrial grade (-40C to +85C )
(ambient temperature exceeds 40 degrees, lower power use, or add one heatsink)
Full load temperature rise: 45 C
No-load Current: Typical 10mA (12V switch to 4.2V)
Load regulation: 1%
Voltage regulation: 0.5%
Dynamic response speed: 5% 200uS
Potentiometer adjustment direction: clockwise (increase), counterclockwise (decrease)
Input reverse polarity protection: No, please comply with our plate or in the input reverse polarity protection diode in series.
Connection mode: welded, plus pin can be directly soldered on the PCB to matching pin, radiator, shell.
